Home/All/
DC 12 Volt 2.1MM Connector E26 E27 Lamp Holder 8 Feet Wiring With On Off Switch
WIRE-E27-2.1MM-2.5M-BLACK
DC 12 Volt 2.1MM Connector E26 E27 Lamp Holder 8 Feet Wiring With On Off Switch
$14.99
A perfect match for Edison DC 12 volt light bulbs , direct fit for any medium base screw to make it work with any 2.1mm jack. This is truly the easiest turnkey solution for your low voltage lighting. Just plug and play from your DC 12V battery or power source with no extra wiring or hassles. Lightweight and compact enough to carry multiple units with ease into remote off grid locations.
Wiring Is 8' long (2.5M) with bright red on off switch on lamp holder.
Great for any portable battery lighting DIY ideas and projects
Ideal for DC 12V and other direct current (DC) voltage systems or battery
Simplify wiring for DC grids and off grid home lighting
Great solution for computers, glamping, camping, solar panel powered buildings, boats, yachts.
Ideal for trains, outdoor battery lighting, RV, motor home, campers, tents, buses
Also use for off grid battery systems and more DIY solutions
Use with 12Vmonster Edison E26 E27 bulbs for a quicker and more convenient installation
It took a good bit of research ('cause I'm no electrician) and a few experiments and adjustments, and I finally created a working battery powered lamp that emits enough light for reading! here's the how-to, in case you find yourself inspired to light up a spot that has no available electrical outlet.
1. LED bulbs take relatively little power. 12 volts is adequate, and it is available by battery. A single AA battery provides 1.5 volts. So, 8 AA batteries in a bank provides 12V. First I tried using a light strip (the adhesive kind that can go under cabinets for task lighting) plugged into an 8 battery bank. However, these light strips are generally only about as bright as a 40 watt incandescent bulb (about 450 lumens), which is not bright enough for reading (need about 800-1000 lumens). I found a 12V, 1000 lumen bulb shaped just like a classic light bulb (called E26) from Norman Lamps.
2. Lamp sockets are generally wired for plugging into 120 volt electrical outlets. Solution here - a 12V light switch with E26 socket that plugs into a battery pack. This came from 12v Monster.
3. A rechargeable battery pack. First I tried a trickle charger (like used for a small engine). However, the cooling fan that was part of the unit was quiet but not silent. I landed on this battery pack at Amazon - TalentCell rechargeable 12V battery w/ AC/DC output
4. Lamp. You can make a lamp out of nearly anything. I used mirror spray paint and a vinegar wash technique on this thrift store vase for an antiqued silver/glass look. A masonry bit to drill a hole for the cord and an old CD to fill the top of the vase and serve as a landing spot for the lamp shade and harp finished it off.
Fritz R.
So far so good
vivian w.
plugs right into my harbor freight solar panel system
shams p.
Items ordered were exactly as required and were sent in time. I am happy, no problem
Derek Sideburn
Portable lamp holder for anywhere
This wire and lampholder, mini DC 12 volt battery bank and a 12V filament bulb are all I needed for my 1 month camping trip in the desert. I had a Goal Zero solar panel and was able to enjoy renewable energy sourced lighting in the middle of no where.
